Autel Maxivideo MV201 User Manual download pdf (Page 17)

Operation Instructions Operation Precautions

likely to cause injury.

 Do not drop the tool, if the tool is dropped accidently, check for

the breakage and any other conditions that may affect its

operation.

 Use only accessories that are recommended by the manufacturer

for the tool.

 Dry your hands when operating the tool or charging the battery.

 Always use appropriate personal protective equipment while

handling and using the tool. Appropriate personal protective

equipment always includes safety glasses and gloves, and may

include latex or rubber gloves, face shields, goggles, protective

clothing, respirators and steel toed footwear.

 Protect against excessive heat. The tool should be kept away

from heat sources such as radiators, stoves or others that produce

heat. Do not use the tool near moving machinery or areas where

the temperature will exceed 113°F (45°C).

 Store the tool, charger and all cables in a locked area out of the

reach of children and people unfamiliar with tool.

5.3 Tool Inspection

WARNING: Before using, inspect your tool and correct any

problems to reduce the risk of serious injury from electric shock and

other causes and prevent tool damage.

 Make sure the power is OFF.

 Clean any oil, grease or dirt from the tool, especially on the

buttons and ports. This helps prevent the tool from slipping from

your hands.

 Inspect the imager head lens for condensation. To avoid

damaging the tool, do not use the tool if condensation forms

inside the imager head. Let the water evaporate before using

again.

 Inspect the full length of the cable for cracks or damage. A

damaged cable could allow water to enter the tool and increase

the risk of electric shock.

 Make sure the connections between the display unit and imager

head and cable are tight. All connections must be properly

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

No comments

Autel Maxivideo MV201 User Manual Page 17